doc:user:geometry:user:surfaces
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
doc:user:geometry:user:surfaces [2015/01/07 17:11] – [Ruled Surface] boman | doc:user:geometry:user:surfaces [2016/04/05 22:47] – wautelet | ||
---|---|---|---|
Line 19: | Line 19: | ||
| '' | | '' | ||
- | Its normal (and therefore the surface orientation) is calculated | + | Its normal (and therefore the surface orientation) is computed |
$\boldsymbol{p_2}-\boldsymbol{p_1}$ et $\boldsymbol{p_3}-\boldsymbol{p_1}$. | $\boldsymbol{p_2}-\boldsymbol{p_1}$ et $\boldsymbol{p_3}-\boldsymbol{p_1}$. | ||
Line 58: | Line 58: | ||
nur.setDegreeU(degU) | nur.setDegreeU(degU) | ||
nur.setDegreeV(degV) | nur.setDegreeV(degV) | ||
- | nur.push(i1, | + | nur.push(i1, |
nur.push(i2, | nur.push(i2, | ||
nur.pushKnotU(knotu1) | nur.pushKnotU(knotu1) | ||
Line 65: | Line 65: | ||
nur.pushKnotV(knotv1) | nur.pushKnotV(knotv1) | ||
... | ... | ||
- | nur.pushKnotV(knotv2) | + | nur.pushKnotV(knotv2) |
+ | |||
+ | with | ||
+ | | '' | ||
| '' | | '' | ||
| '' | | '' | ||
Line 80: | Line 82: | ||
revsur = surfaceset.add( RevolutionSurface(number, | revsur = surfaceset.add( RevolutionSurface(number, | ||
- | where | + | with |
+ | | '' | ||
| '' | | '' | ||
| '' | | '' | ||
+ | ===== Sphere | ||
+ | |||
+ | |||
+ | c = Sphere(number, | ||
+ | |||
+ | with | ||
+ | | '' | ||
+ | | '' | ||
+ | | '' | ||
+ | | '' | ||
===== Cylinder ===== | ===== Cylinder ===== | ||
Line 93: | Line 105: | ||
c.setProjType(projType) | c.setProjType(projType) | ||
- | where | + | with |
+ | | '' | ||
| '' | | '' | ||
| '' | | '' |
doc/user/geometry/user/surfaces.txt · Last modified: 2016/11/14 10:30 by wautelet