applications:mf:superplastic
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
applications:mf:superplastic [2015/01/11 23:25] – canales | applications:mf:superplastic [2024/02/26 17:00] (current) – boman | ||
---|---|---|---|
Line 1: | Line 1: | ||
~~NOTOC~~ | ~~NOTOC~~ | ||
- | \\ {{ : | + | {{ : |
====== Superplastic forming ====== | ====== Superplastic forming ====== | ||
* Superplasticity is a state in which a material is deformed well beyond its usual breaking point (high T, ultra low strain rates). | * Superplasticity is a state in which a material is deformed well beyond its usual breaking point (high T, ultra low strain rates). | ||
Line 7: | Line 7: | ||
* Optimal pressure cycle is computed in order to stay below a given plastic strain rate. | * Optimal pressure cycle is computed in order to stay below a given plastic strain rate. | ||
- | \\ <html> | + | <WRAP centeralign column 100%> |
- | <iframe width=" | + | {{url>// |
- | </html> | + | </WRAP> |
- | \\ {{ : | + | ---- |
+ | |||
+ | {{ : | ||
* Importation of an industrial geometry including NURBS curves and surfaces. | * Importation of an industrial geometry including NURBS curves and surfaces. | ||
* Superplastic Forming with optimization of the applied pressure cycle. | * Superplastic Forming with optimization of the applied pressure cycle. | ||
- | \\ \\ \\ \\ \\ \\ \\ \\ <html> | + | \\ \\ \\ \\ \\ \\ \\ \\ |
- | <iframe width=" | + | |
- | </html> | + | <WRAP centeralign column 100%> |
+ | {{url>// | ||
+ | </WRAP> |
applications/mf/superplastic.txt · Last modified: 2024/02/26 17:00 by boman