doc:user:geometry:user:courbes
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
doc:user:geometry:user:courbes [2015/01/07 17:30] – [PythonCurve: Python-interpreted Curves] boman | doc:user:geometry:user:courbes [2015/01/07 17:33] – boman | ||
---|---|---|---|
Line 10: | Line 10: | ||
{{ doc: | {{ doc: | ||
- | ===== Line: straight segment | + | ===== Line: Straight Segment |
{{ doc: | {{ doc: | ||
Line 22: | Line 22: | ||
| '' | | '' | ||
- | ===== Arc ===== | + | ===== Arc: Arc of Circle |
- | {{ doc: | + | {{ doc: |
An '' | An '' | ||
Line 37: | Line 37: | ||
===== Cubic Spline ===== | ===== Cubic Spline ===== | ||
- | {{ doc: | + | {{ doc: |
- | ==== " | + | ==== " |
spl = curveset.add( CubicSpline(number, | spl = curveset.add( CubicSpline(number, | ||
Line 59: | Line 59: | ||
==== Spline-reconstruction based on a mesh ==== | ==== Spline-reconstruction based on a mesh ==== | ||
- | {{ : | + | {{: |
It is possible to construct a spline based on the mesh of a line. This way, a smooth approximation of this mesh if obtained. | It is possible to construct a spline based on the mesh of a line. This way, a smooth approximation of this mesh if obtained. | ||
Line 66: | Line 66: | ||
where '' | where '' | ||
- | ===== Full Circle ===== | + | ===== Circle: |
- | {{ doc: | + | {{ doc: |
A circle is defined with its center and radius (this function is only defined in the $z=0$ plane) | A circle is defined with its center and radius (this function is only defined in the $z=0$ plane) | ||
Line 88: | Line 88: | ||
A Non-Uniform Rational Basis Spline (N.U.R.B.S.) is defined as: | A Non-Uniform Rational Basis Spline (N.U.R.B.S.) is defined as: | ||
- | {{ doc: | + | {{ doc: |
nur = curset.add( NurbsCurve(number) ) | nur = curset.add( NurbsCurve(number) ) |
doc/user/geometry/user/courbes.txt · Last modified: 2016/03/30 15:23 by 127.0.0.1