doc:user:conditions:dead_loads
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
doc:user:conditions:dead_loads [2013/07/12 13:28] – joris | doc:user:conditions:dead_loads [2015/01/08 17:07] – boman | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | | ||
+ | ====== Prescribed Nodal " | ||
+ | | ||
+ | Dead loads are forces that are directly prescribed at the nodes of the mesh. The amplitude and direction of such forces is known a priori. In particular it is independent from the deformation of the underlying material. Such forces also strongly depend on the chosen mesh desnity. Changing the mesh usually requires a complete redefinition of these forces. | ||
+ | |||
+ | <note important> | ||
+ | |||
+ | Anyway, the command used for the definition of "dead loads is the same as [[doc: | ||
doc/user/conditions/dead_loads.txt · Last modified: 2016/03/30 15:23 by 127.0.0.1