Metafor

ULiege - Aerospace & Mechanical Engineering

User Tools

Site Tools


doc:user:tutorials:tuto1

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
doc:user:tutorials:tuto1 [2016/07/11 16:06]
boemer [Mesh]
doc:user:tutorials:tuto1 [2016/07/11 16:45] (current)
boemer [Temporal Integration]
Line 388: Line 388:
 The deformable entity is specified with the command ''push()'', the rigid one with ''setTool()''. The deformable entity is specified with the command ''push()'', the rigid one with ''setTool()''.
  
-It should be noted that the contact interaction number must be different that the ''FieldApplicator'' number defined earlier, since both objects are included in the same set ''InteractionSet''.+It should be noted that the contact interaction number must be different from the ''FieldApplicator'' number defined earlier, since both objects are included in the same set ''InteractionSet''.
 ==== Temporal Integration ==== ==== Temporal Integration ====
  
 The description of this model is now over. What is left to consider is the way the ''Metafor'' analysis, in charge of running the simulation, will integrate the equations temporally. The description of this model is now over. What is left to consider is the way the ''Metafor'' analysis, in charge of running the simulation, will integrate the equations temporally.
  
-Many options are available, however the simplest one is chosen here, which is a quasi-static integration (where the inertia is neglected). What remains to define is the temporal interval on which the simulation will be run, and the way the results will be saved (see [[doc:user:integration:general:time_step]]).+Many options are available, however the simplest one is chosen here, which is a quasi-static integration (where the inertia is neglected). What remains to be defined is the temporal interval during which the simulation will be run, and the way the results will be saved (see [[doc:user:integration:general:time_step]]).
  
  
Line 412: Line 412:
      
  
-Afterwards, the ''MechanicalIterationManager'' is considered (see [[doc:user:integration:general:mim_tim]]). This object sets the parameters of Newton-Raphson algorithm, used to solve the equilibrium equations. Here, a maximum of 7 mechanical [[doc:user:general:glossaire#iterations]] is set, with the default tolerance of 1.0e-4.+Afterwards, the ''MechanicalIterationManager'' is considered (see [[doc:user:integration:general:mim_tim]]). This object sets the parameters of the Newton-Raphson algorithm, used to solve the equilibrium equations. Here, a maximum of 7 mechanical [[doc:user:general:glossaire#iterations]] is set, with the default tolerance of 1.0e-4.
 ==== Curves Extraction  ==== ==== Curves Extraction  ====
  
doc/user/tutorials/tuto1.1468245995.txt.gz · Last modified: 2016/07/11 16:06 by boemer