Differences

This shows you the differences between two versions of the page.

--- doc:user:geometry:user:courbes [2015/01/07 17:32] – [Full Circle] boman
+++ doc:user:geometry:user:courbes [2015/01/07 17:33] – [Line: Straight Segment] boman
@@ Line 12: / Line 12: @@
 ===== Line: Straight Segment =====
-{{ doc:user:doc-droite.png|}}
+{{ doc:user:doc-droite.png |}}
 A ''Line'' (line segment) is defined with its two vertices.
@@ Line 24: / Line 24: @@
 ===== Arc: Arc of Circle =====
-{{ doc:user:doc-arc.png|}}
+{{ doc:user:doc-arc.png |}}
 An ''Arc'' of circle is defined using three points, as shown on the figure.
@@ Line 37: / Line 37: @@
 ===== Cubic Spline =====
-{{ doc:user:doc-spline.png|}}
+{{ doc:user:doc-spline.png |}}
 ==== "Open" Cubic Spline ====
@@ Line 68: / Line 68: @@
 ===== Circle: Full Circle =====
-{{ doc:user:doc-cercle.png|}}
+{{ doc:user:doc-cercle.png |}}
 A circle is defined with its center and radius (this function is only defined in the $z=0$ plane)
@@ Line 88: / Line 88: @@
 A Non-Uniform Rational Basis Spline (N.U.R.B.S.) is defined as:
-{{ doc:user:doc-nurbs.png|}}
+{{ doc:user:doc-nurbs.png |}}
   nur = curset.add( NurbsCurve(number) )