doc:user:conditions:dead_loads
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
doc:user:conditions:dead_loads [2013/07/12 19:27] – external edit 127.0.0.1 | doc:user:conditions:dead_loads [2016/03/30 15:23] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
| | ||
- | ====== | + | ====== |
+ | | ||
+ | Dead loads are forces that are directly prescribed at the nodes of the mesh. The amplitude and direction of such forces is known a priori. In particular it is independent from the deformation of the underlying material. Such forces also strongly depend on the chosen mesh desnity. Changing the mesh usually requires a complete redefinition of these forces. | ||
+ | <note important> | ||
- | Les charges mortes sont des charges nodales dont la direction et l' | + | Anyway, the command used for the definition of "dead loads is the same as [[doc: |
- | Pour obtenir une charge continuellement perpendiculaire à la surface de l' | ||
- | |||
- | __Attention!__ La valeur spécifiée pour les charges mortes s' | ||
- | |||
- | {{ doc: | ||
- | |||
- | La commande est la même que pour les [[doc: | ||
- |
doc/user/conditions/dead_loads.1373650079.txt.gz · Last modified: 2016/03/30 15:22 (external edit)